Installation Of The Heater Sensor - Monuments IRON I Gebrauchsanweisung

• Attach the two wall xtures to the rear of the sauna heater using the 6 llister head screws M4. Ensure that the sides
with the keyholes for attachment are always in the right position toward the outside of the sauna heater.
• Now you can hook the keyholes of the sauna heater onto the spax screws that are screwed into the cabin wall and then
secure on the wall xtures with the two locking screws. (Fig. 8).
• Connect the power cable to the control unit. Please pay attention to the local PU and VDE regulations.

Installation of the heater sensor

Mount the oven sensor in cabins up to 2x2 m according to Fig 9 and 11, in larger cabins according to Fig. 10 and 11. If
the assembly instructions for your sauna control unit states a di erent position for the sensor, always use this position
for the oven sensor.
< 2 x 2 m
Fühlerleitung
19 cm
Sauna
control unit
Fig. 9
28
> 2 x 2 m
Fühlerleitung
35 cm
Sauna
control unit
Fig. 10
GB
Spax screws
Wall mount xture
with keyholes
Corrugated-head screw
Fig. 8
20 cm
Fig. 11