Monuments IRON I Gebrauchsanweisung Seite 27

• Attach the enclosed ba e as shown in Fig. 5. To do this, rst release the central screw on the lid and attach it using
this and two other tapping screws 4.2 x 9.5 from the poly bag.
• Open the rear lid of of the connection box (release 2 screws) as shown in Fig. 6 and remove the lid downwards.
Connection box lid
• Connect the power cable as shown in the wiring diagram.
• There is a wiring diagram attached on the inside of the connection box.
• Electrical connection acc. to Fig. 7 and connection example.
Terminal
Counternut
Cable screw connection
Connection box lid
• Check that all clamps are tightened correctly.
• Close the connection box and the lid again using the two screws. Ensure that the lid is pushed under the edge of the
connection box as far as possible.
Loosen screws
GB
Figure 5
Fig. 6
Fig. 7
27