Removing The Oliboard Software; Running The Software; Starting The Driver Of The Interactive Whiteboard - Olivetti Oliboard 78S Benutzerhandbuch

R O
EMOVING THE
Click on "Start" → "Control Panel" → "Add or Remove Programs", select
"Oliboard" then click on "Add/Remove".
Select the option for removing all the features installed and follow the instructions
shown on the screen.
Alternatively, insert the software disk, click on the Oliboard program logo and run the
software removal guide following the instructions on the screen.
At the end of removal, it is recommended that you restart the computer.
R S
UNNING THE OFTWARE
The whiteboard cable must be connected to the USB port of the computer.
To run the software, first of all the software driver of the whiteboard must be started,
the orientation operation performed if necessary, after which the whiteboard software
can be started.

Starting the Driver of the Interactive Whiteboard

Click "Start" → "All programs" → "Olivetti" → "Oliboard Software " and start
the Oliboard Driver. The Communications module icon
corner of the Status bar on the desktop.
NOTE: If the message "Communication with whiteboard failed", first make
sure that the cable of the whiteboard is connected correctly between
the computer and the whiteboard. Click on the Oliboard Driver icon
and select "Reconnect" in the popup menu. If this warning persists,
make sure that the driver of the USB cable is installed correctly (see
the note on how to check installation of the USB cable on page 13).
14
S
LIBOARD OFTWARE
appears in the lower right
OLIBOARD - Interactive Whiteboards