Manual Roldeck Operation - STARLINE Roldeck Anleitung

7.4 Manual Roldeck Operation

Only in case of RD2006 type, from serial
number 5124376 on. If the roldeck's motor
doesn't work anymore due to a sensor
problem (the ERROR LED flashes 2x in that
case, refer to failure table on page 20), the
sensor's function can be disabled by means
of a buttons/programming plug combination.
Refer to the procedure in figure 1, 2 and 3.
First, turn on the control by means of the red
switch (A) and put the programming plug (B)
in the connector (C).
Then, press simultaneously the Mode (D)
and Close (E) buttons for 3 seconds.
Manual Roldeck operation is an
emergency procedure, as a result
the set start and and end position
(program) will be cleared from the
memory
and must be programmed again.
Next, the Roldeck can be operated
manually by pressing and holding the Open
(F) or Close (G) button on the key switch
until the Roldeck will go to the desired
position.
The Roldeck will not stop
automatically, make sure the
Roldeck doesn't move too far when
opening or closing.
24
User manual Starline Roldeck
RDCM – V01
A
D
E
F
G
C B