Remote Control (Optional) - STARLINE Roldeck Anleitung

5.3 Remote Control (optional)

The remote control transmitter is pre-
programmed.
If the transmitter is replaced, or if the
number of transmitters is expanded, follow
the procedure below.
Make sure that the transmitter and
the receiver will not be more than
50 meter distance from each other
during programming.
First transmitter programming:
• Keep the programming key (B) pressed
for about 1 second. The LED (C) on the
receiver will flash.
• Press the transmitter key (A) within 20
seconds and hold it until the LED won't
light anymore. The transmitter has been
programmed.
Second transmitter programming:
• Keep the programming key (B) pressed
for about 0.5 second. The LED (C) on
the receiver will flash.
• Press the transmitter key (A) within 20
seconds and hold it until the LED won't
light anymore. The second transmitter
has been programmed.
Deleting old settings:
• Press and hold the programming key
(B) until the LED (C) on the receiver
will light. The LED will light until all old
settings have been deleted (about 10
seconds).
Deleting the settings from a single
transmitter is not possible. The
settings from all transmitters will be
deleted.
User manual Starline Roldeck
RDCM – V01
A
C
B
13