5
Roldeck Control Programming
5.1 Roldeck Control
Programming of the Roldeck control occurs
with the help of the operational control
panel on the programming cabinet.
• Place the programming plug in the
programming cabinet's connector.
Leave the programming plug
connected during use.
•
Press simultaneously PROG and
MODE for 5 seconds. The yellow LED
(ROLDECK) will flash. Control has been
reset.
•
Press OPEN to bring the Roldeck to the
desires 'fully open' position.
If the motor (you have moter at present).
Caution:
•
If the moter has an incorrect rotational
direction, the polarity must be switched.
The motor will start with a reduced
rotational speed. The rotational
speed will increase after 5 seconds.
10
User manual Starline Roldeck
RDCM – V01
± 5 sec.