Inhaltsverzeichnis
Werbung
Using the remote control
The remote control is able to control all the functions of the
hood:
Select the suction speed (power)
Light ON/OFF
Not implemented
Not implemented
Selecting the suction speed (power):
Press the "◄" key or the "►" key until you see the symbol
relating to the "Select the suction speed (power)" function.
Press the "+" key or the "-" key or the "■" key respectively to
increase or diminish or switch off (stand-by) the speed
(suction power).
Light ON/OFF:
Press the "◄" or "►" button, until the LED corresponding to
the "Light ON/OFF" symbol appears on the remote control.
Press the "+" or "-" button to put on or off the lights.
Press the "■" to change the status of the lights, from off (all
lights) to on (all lights) and vice-versa.
Configuration of the remote control
To enable the remote control, proceed as follows:
Press the "◄" or "►" button until you can see on the remote
control the symbol "
" related to the function "Reset and
configuration of the filter saturation signalling" and press
continuously on the central button "■" for at least 5 seconds.
An audible signal indicates the successful configuration.
Maintenance of the remote control
Cleaning the remote control:
Clean the remote control with a damp cloth and a neutral
solution of detergent without abrasive substances.
Changing the battery:
•
Open the battery casing using a small screwdriver with a
flat point.
•
Change the finished battery with a new one of 12 V type
MN21/23
In inserting the new battery respect the polarity indicated
on the battery casing!
•
Close the battery casing up again.
Disposal of the batteries
Ultimate disposal of the batteries should be handled according
to all national laws and regulations. Do not place used
batteries in your regular waste.
Ultimate disposal of the batteries must be done
Contact your local waste management officials for other
information regarding the environmentally sound collection,
recycling, and disposal of the batteries.
safely.
34
Werbung
Inhaltsverzeichnis
