Oven - Using The Accessories - Zanussi ZCG51011WA Benutzerinformation

Oven Functions
Oven function
Off position
Pizza setting
1 - 8 Heat settings
1) 1 - 135°C, 2 - 150°C, 3 - 165°C, 4 - 180°C, 5 - 195°C, 6 - 210°C, 7 - 230°C, 8 - 250°C
Manual ignition of oven gas burner
Oven safety device: The gas oven
has a thermocouple. It stops the gas
flow if the flame goes out.
1. Open the oven door.
2. Hold the flame near the hole in the bottom
of the oven cavity.
3. At the same time push the knob for the
oven functions and turn it counterclockwise
to the maximum gas flow position.
4. When the flame comes on, keep the knob
for the oven functions pushed on the

Oven - Using the accessories

WARNING!
Refer to Safety chapters.
Inserting the accessories
Wire shelf:
The wire shelf has a special shape in
the rear which help with the heat
circulation.
www.zanussi.com
Application
The appliance is off.
To make pizza.
Range of temperature levels adjustment for the oven
maximum gas flow position for 15 seconds
or less to let the thermocouple warm up.
Do not keep the knob for the oven
functions pushed for more than 15
seconds. If the oven burner does not
light after 15 seconds, release the
knob for the oven functions, turn it
into off position, open the oven door
and try to light the oven burner again
after minimum 1 minute.
After ignition of oven gas burner
1. Release the knob for the oven functions.
2. Close the oven door.
3. Turn the knob for the oven functions to set
the necessary heat setting.
Control the flame trough the holes in the bottom
of the oven.
Turning off the oven burner
To put out the flame, turn the knob to the off
position.
Push the shelf on the shelf position. Make sure
it does not touch the back wall of the oven.
Tray:
1)
.
9