Zanussi ZCG51011WA Benutzerinformation Seite 18

WARNING!
The gas connection pipe must not
touch the part of the appliance
shown in the illustration.
Flexible nonmetal pipes connection
If you have an easy access to the connection,
you can use a flexible pipe. The flexible pipe
must be tightly attached by clamps.
In installation always use the pipe holder and
the gasket. The flexible pipe can be applied
when:
• it can not get hotter than room temperature,
higher than 30 °C;
• it is not longer than 1500 mm;
• it has no narrowing anywhere;
• it is not twisted or tighten;
• it does not get in touch with sharp edges or
corners;
• it's conditions can be easily checked.
When checking the flexible pipe make sure:
• it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length;
• the material is not hardened, but shows its
correct elasticity;
• the fastening clamps are not rusted;
• expired term is not due.
If one or more defects are visible, do not repair
the pipe, but replace it.
WARNING!
When installation is complete, make
sure that the seal of each pipe fitting
does not leak. To check the seal use
a soap solution, not a flame.
The gas supply ramp is on the rear side of the
control panel.
WARNING!
Close the primary valve of the gas
supply.
18
The appliance is set to default gas.
To change the setting choose a pipe
holder from the list. Always use the
gasket sealing.
A
A) Gas connection point (only one point is
applicable for the appliance)
B) Gasket
C) Adjustable connection
D) Natural Gas pipe holder
E) LPG pipe holder
Adjustment to different types of gas
WARNING!
Let only an authorized person do the
adjustment to different types of gas.
This appliance works with natural
gas. With the correct injectors, you
can also operate it with liquid gas.
The gas rate is adjusted to suit.
WARNING!
Before you replace the injectors,
make sure that the gas knobs are in
the Off position. Let the appliance
cool down. There is a risk of injury.
Hob injectors replacement
Replace the injectors when you change the gas
type.
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. Remove the injectors with a socket spanner
7.
4. Replace injectors with the ones necessary
for the type of gas you use.
B C
E D
www.zanussi.com