Garantie, Garanzia, Guarantee - Zanussi ZCG51011WA Benutzerinformation

Assemble the burner in a revers sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new gas
type.
Adjustment of minimum level at the
oven burner
1. Remove the knob for the oven functions.
If there is no access to the bypass screw
dismount the control panel before adjustment
start.
2. Adjust the bypass screw (A) with a thin and
flat screwdriver.
Positions of the bypass screw (A) depends on
model.
A
Change from natural gas to liquid gas
1. Fully tighten the bypass screw.
2. Put the knob back.
Change form liquid gas to natural gas
1. Unscrew approximately one turn the bypass
screw position (A).

Garantie, Garanzia, Guarantee

CH
Kundendienst, service-clientèle, Servizio
clienti, Customer Service Centres
Servicestellen
5506 Mägenwil/
Zürich Industries-
trasse 10
20
Points de Service
3018 Bern Morgen-
strasse 131
2. Put the knob back.
3. Light the burner.
Refer to "Oven - Daily use" chapter.
4. Turn the knob on the minimum position.
5. Remove the knob again.
6. Screw on slowly the bypass screw till the
flame becomes minimum and stable.
7. Put the knob back.
8. Set the maximum gas flow position on the
oven knob and let the oven heat for at least
10 minutes.
9. Quickly turn the knob for the oven functions
from maximum to the minimum gas glow
position.
Control the flame. Make sure the flame does not
go out when you turn the knob to the minimum
gas flow position. There must be a small regular
flame on the oven burner crown. If the flame
goes out adjust the oven burner again.
Levelling of the appliance
Use small feet on the bottom of appliance to set
the appliance top surface level with other
surfaces.
Servizio dopo ven-
dita
1028 Préverenges Le
Trési 6
Point of Service
6928 Manno Via Vio-
lino 11
www.zanussi.com