Niceboy SOUNDmaster Bedienungsanleitung Seite 17

The top buttons background light hand induction function – 23
• The frosted LED backlighting for buttons will be lighten up by human hand heat, easy to use in
darkness.
INSTRUCTIONS
•
Reset
When the machine crashes, it will not play properly or shutdown. Press the power button for about 8
seconds. After release, the machine will reset. Pressing the power button again will reboot the device.
•
Charging
Charging is done by Mini 5p USB port. Battery indicator lights correspond to 1/3 of battery capacity.
When device is fully charged, all three indicator lights will be on. When device is low in charge, the
battery indicator light will flash red and a beeping sound will alert the user.
•
Bluetooth
1. To connect your speaker to a Bluetooth enabled device, power on your speaker and press the
play button; Bluetooth pairing indicator light will flash red and blue, and the system will then enter
pairing mode(signaled by a voice prompt).
2. Pairing mode will automatically be canceled (signaled by a beep) after 3 minutes. To re-enter
pairing mode, simply begin again at step #1.
3. Make sure that Bluetooth is enabled on the device you wish to pair with.
4. When scanning for available devices, the speaker should appear as "SOUNDmaster" on the list of
found devices.
5. When selecting "SOUNDmaster" from the list, you may be prompted to enter a PIN code (someti-
mes called a "Passkey", "PIN Number" or "Password"), the code for this device is "0000".
6. The speaker will record this device as the last device paired.
7. Finally, activate the Bluetooth connection from your phone or other device(some devices may do
this automatically).
8. Incoming calls will override music and other media with an "incoming call"voice alert, simply press
the Phone button to answer or press and hold to reject/end the call. Press the Phone button to
answer a second incoming call.
9. Press the Phone button to activate the "siri" or S-Voice function of your phone.
•
Functional Mode Conversion
If device has already paired with phone, turning the device on will automatically allow it to re-connect.
EN
17