Installation Requirements - ECG TK 2050 Bedienungsanleitung

INSTALLATION REQUIREMENTS

• Place the convector on a flat surface with a sufficient amount of space around the appliance to ensure the
proper function of exhaust vents.
• There must be a distance at least 90 cm between the device and the surrounding objects.
WARNING:
The surfaces marked this way become hot during use.
DO NOT COVER!
OPERATING INSTRUCTIONS
GB
This convection heater uses convection technology with temperature control by thermostat.
The power level can be set via heat element switches:
Switch 1 = power of 750 W
Switch 2 = power of 1250 W
Switch 1+2 = power of 2000 W
Turning on the convector and temperature control.
1. With respect to the above defined safety instructions, select a proper location to place the convector.
2. Plug the power cable into a proper electric socket.
3. Turn the THERMOSTAT CONTROL completely to the right for maximum power.
4. Activate the heat elements via the SWITCHES on the side panel. The activation of heat elements is indicated
by switch indicator lights. Activate both switches to achieve maximum heat power.
5. When the room has reached the desired temperature, turn the thermostat slowly to the left until the
thermostat clicks and the indicators on the heaters' switches turn off. The convector will now automatically
switch on and off the heating elements to keep the room temperature at a set value.
Note: When first switched on or switched on after a long period of inactivity, the heaters may emit odor or
smoke. This is normal and it will fade away in a short while.
Turning off the convector
• First, turn the convector off and set the thermostat control to position „MIN", then always unplug the
power cable from the outlet.
• Any manipulation with the device can be performed only if the switches are turned off and it is unplugged
from the outlet.
Protection against overheating
• The internal thermal fuse protects the heater from overheating and shuts it off automatically. In this case
the operating indicator lights turns off.
• If the device shuts itself, unplug the power cable from the outlet. When it cools (in about 15 minutes), the
device is again ready for use. Plug the power cable back into the socket.
• If the situation repeats itself, check first, if the thermostat control is properly set and if the ventilation
openings of the device are not covered.
CLEANING
• Before cleaning always unplug the power cable from the outlet and let it cool entirely.
• Clean the out surface with a damp cloth and polish it with dry cloth. Do not use detergents or abrasive
cleaners and prevent water from entering the device.
34
To prevent the device from overheating, do not cover the heater.
The heater must not be placed directly under an outlet.