Operating Conditions - Kermi IDE10 Gebrauchs- Und Montageanleitung

EN – Installation instructions
The radiator may only be installed by a special-
ized tradesman.
The following activities may only be performed
•
Connection of the electric set
•
Connection of the heating element to the
electric set
Safety instructions
Read these instructions thoroughly prior to
installation.
After installation pass the instructions on
to the end user.
Observe the safety directions in the sepa-
rate electric set instructions.
DANGER
Life-threatening situation!
Check the condition of the supply lines
(electricity, gas, water).
Do not drill into any lines.
WARNING
Risk of injury!
Take the radiator's weight into account
(see page 32).
At 25 kg and above, work with lifting
equipment or several persons.
WARNING
Personal injury and material damage!
Check the base for adequate carrying
capacity. Take the radiator's weight (see
page 32) and possible additional loads
into account.
Check fasteners for applicability and tai-
lor them to the structural situation.
Special requirements, e.g. for public
buildings (schools or the like), must be
taken into account.

Operating conditions

Take protective areas according to DIN VDE
0100-701 into account. Also follow all local
regulations.
Do not connect the radiator to the heating
system.
Operate the heating element only with the
voltage approved (see rating plate).
Observe limitations of use in damp loca-
radiators".
Store and transport radiator only in the
protective packaging.
Make allowance for minimum clearances
between the radiator and adjacent parts
Complaint
Contact the supplier.
Disposal
Packaging and any parts that are not need-
ed should be recycled or disposed of prop-
erly. Observe local regulations.
Technical features
•
–
Heating element installed on the radia-
tor at the bottom right or left
–
Connection via electric set
•
•
fer liquid
•
of the heating system, with adjustment via
electric set
-
5