Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
______________(EN)______________
INSTRUCTION MANUAL
WARNING:
Before using the equipment, read
carefully all instructions.
1. GENERAL SAFETY FOR OPERATING
THIS EQUIPMENT
- During charging, the batteries emit
explosive gasses: avoid generating
flames and sparks. DO NOT SMOKE.
- Before carrying out the test, position the
batteries in a ventilated place.
- In
order
to
the
vehicles'
read, store safely and scrupulously
observe the instructions provided by
the manufacturers of the vehicles
themselves;
indications supplied by the batteries
manufacturer.
- DO NOT SET IN THE RAIN OR SNOW.
- Keep away from the reach of children.
- Protect the eyes. Always wear protective
goggles when working on lead-acid
batteries.
- Avoid contact with battery acid. Should
anyone be sprayed by or come into
contact with the acid, wash immediately
the part involved with clean water.
Continue to rinse until a doctor will
attend to the person affected.
- It is important to connect the cables
to the correct polarities. Connect the
red clamp (+) to the battery's positive
terminal, the black clamp (-) to the
negative (earth).
- Use this equipment in well ventilated
areas.
prevent
damage
electronics,
carefully
the
same
applies
- Prevent black and red clamps coming
into contact when they are connected
to the battery, since this can cause
the melting of the batter or other metal
objects.
- Wear appropriate clothing. Do not wear
flapping garments or jewellery that might
get caught into moving parts. While
working, the use of electrically insulated
protective clothing is recommended as
well as anti-slip footwear. Should long
hair be worn, wear a cap to contain
them.
2.
INTRODUCTION
DESCRIPTION
Digital lead battery tester (Diag. A.) This
device allows you to check:
A. the charge status and starter current
capacity of the 12V lead battery used on
the vehicles (BATTERY TEST).
The maximum and minimum current
to
output settings (CCA) are:
- EN: 185 ÷ 1125 A
- IEC: 130 ÷ 790 A
- DIN: 110 ÷ 670 A
- SAE: 200 ÷ 1200 A
to
- CA (MCA): 240 ÷ 1440 A
B. that the vehicle starter system is working
properly (STARTER SYSTEM TEST).
C. that the vehicle charging circuit is
working properly (CHARGING SYSTEM
TEST).
The recommended ambient temperature
when using the tester is from 0°C to 40°C.
3. OPERATING PROCEDURES
BEFORE COMMENCING THE TEST:
- Check the battery terminals are clean.
- Inspect the battery: do not test a battery
if any of its parts or its container is
damaged.
- Check that the area in the vicinity of the
battery being tested is well ventilated.
- Before testing a vehicle battery, remove
the ignition key, turn off the lights,
disconnect all accessories, and close all
the doors, including the boot.
- Check that the 9V battery (included in
the pack) is fitted inside the tester. If a
warning appears on the display - "ibtL"
(INTERNAL BATTERY LOW) – replace
the battery with a fully charged one.
N.B.: the display only comes on when
the tester is connected to the vehicle
battery.
TESTING THE BATTERY
- Connect the red clamp (+) to the positive
battery terminal, and the black clamp
3
AND
GENERAL
Werbung
Inhaltsverzeichnis
