Front Panel; Rear Panel; Safety Notes - IMG STAGE LINE TXS-871 Bedienungsanleitung

Receiver for a Wireless Microphone
These instructions are intended for users without
any specific technical knowledge . Please read these
instructions carefully prior to operating the unit and
keep them for later reference .
All operating elements and connections de-
scribed can be found on the fold-out page 3 .
1 Overview

1.1 Front panel

1 Volume control for the output level at the out-
puts AF OUT . (9) and (10)
2 Multifunction LC display (fig . 2)
a indication SCAN: flashes in the adjusting
mode "SCAN" (automatic frequency scan-
ning)
b indication AF ("Audio Frequency") for
the volume of the audio signal received
[independent of the volume control (1)]:
the longer the bar graph, the higher the
volume level
c indication RF ("Radio Frequency") for the
re ceived power of the radio signal: the
longer the bar graph, the better the recep-
tion
d battery status indication: indicates the
charging status of the batteries of the
transmitter
e indication PEAK for the audio signal re-
ceived: should only shortly light up with
signal peaks; if it lights up permanently, the
audio signal is overloaded
f indication FREQ .: flashes in the adjusting
mode "FREQ ." (manual frequency adjust-
ment)
g reception indication
which of the two receiver sections of the
unit receives the more powerful radio signal
h indication MUTE: indicates that the receiver
is muted because it receives either a radio
signal which is too poor or no radio signal
at all
i indication of the frequency adjusted
3 Key SET for calling up and exiting the adjusting
modes "FREQ ." (manual frequency adjustment
8
or : indicates
A B
chapter 5 .1 .1) and "SCAN" (automatic fre-
☞
quen cy scanning
4 Cursor keys for frequency adjustment
– in the mode "FREQ .":
to increase the frequency
to reduce the frequency
– in the mode "SCAN":
frequency scanning upwards
frequency scanning downwards
Outside the adjusting modes, the key serves
for activating and deactivating the lock func-
tion: keep the key pressed until the display
indicates (lock on) or
5 Power switch

1.2 Rear panel

6 Reception antennas
7 Strain relief for the cable from the power sup-
ply unit
8 Power supply jack for connection of the power
supply unit provided
9 Unbalanced output jack AF OUT . UNBAL .
(6 .3 mm jack) for connecting a line input of a
mixer or amplifier
10 Balanced output AF OUT . BAL . (XLR) for con-
necting a balanced microphone input of a
mixer or amplifier
11 BNC antenna jacks ANT . 1 and ANT . 2 for the
two supplied antennas (6)
2

Safety Notes

The units (receiver and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING The power supply unit is supplied
with hazardous mains voltage .
Never make any modifications to
the power supply unit . Inexpert
handling may cause an electric
shock hazard .
•
The units are suitable for indoor use only . Protect
them against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range 0 – 40 °C) .
☞ chapter 5 .1 .2)
(lock off)
.