Prepare The Receiver Collar - Petsafe ST-350-LD Gebrauchsanweisung

STEP 2

Prepare the Receiver Collar

Charge the Receiver Collar
1. Lift the rubber cover
protecting the Receiver
Collar Charging Jack.
2. Connect the charger
connector to the
Receiver Collar
Charging Jack.
3. Plug the charger into a
standard wall outlet.
4. Charge the Receiver
Collar until the Green LED comes on and is solid. Recharges take only 3-4 hours.
5. When charging is completed, replace the rubber cover.
To Turn the Receiver Collar On
1. Press and hold the On/Off
Button until the Green LED comes
on and the Receiver Collar
beeps low to high.
2. Release the On/Off button. The
Green LED will flash once every
5 seconds until the Receiver
Collar is turned off. The flashing
light indicates the Receiver Collar
is ready to receive a radio signal from the Handheld Remote.
3. Once the Receiver Collar has been turned on, press the Tone Button (upper left - green) of the
Handheld Remote. Upon pressing, the Receiver Collar should beep for as long as the Tone
Button is pressed. If it does not, see "To Pair the Handheld Remote and the Receiver Collar".
Note: To extend the life of the battery, turn the Receiver Collar off when it is not in use.
350 m Receiver Collar
350 m Receiver Collar 900 m Receiver Collar
www.petsafe.net
900 m Receiver Collar
13