Installation; Power Supply; Mounting The Lens; Installing The Camera - Abus TVIP52501 Bedienungsanleitung

2. Installation

Make sure that all previous listed accessories were included in scope of delivery. In order to operate the
camera an Ethernet network cable is necessary. The cable has to comply with specifications of UTP
categories 5 (CAT 5) and must not exceed 100 meters of length.

2.1 Power supply

Before you start the installation make sure that the mains voltage and the nominal voltage of the camera
correspond.

2.2 Mounting the lens

The camera can be used only with CS mount lens.
In order to use Auto-Iris (AI) lens the connector for the cable can be found on the left side of the camera. You
can also use a manual lens. The camera will automatically recognize the type of lens. For the best possible
picture quality an AI lens is recommended.
The content of delivery for this network camera does not include a lens. Please ensure you are
using a suitable megapixel lens for camera operation.

2.3 Installing the camera

For installing the camera to wall you need to mount the camera bracket to the bottom of the camera. If the
installation of the camera is on a ceiling you first need to mount the socket to the top of the camera with the
included screws. You can then mount the camera bracket to the socket.
ATTENTION!
Make sure to disconnect the camera from the power supply during installation.
ATTENTION!
Never point the camera with opened iris towards the sun. This can damage the image sensor.
66
English