Storch Quick Mixx 25 Bedienungsanleitung Seite 47

Grip positions when starting up
Please be careful when starting up the electric mixer.
Ensure you are holding it properly.
Maintenance
Before servicing the tool disconnect the power supply to reduce the risk of injury from an unexpected start up
or electric shock.
Keep the tool clean. Remove accumulated dust from working parts. Make sure that the tool operates properly.
Periodically check screws and bolts for tightness.
Cleaning the mixer
After about 50 running hours use pressurised dry air to clean all ventilation slots. Regularly clean all plastic parts with a
soft, damp cloth. NEVER clean plastic parts with solvents.
When working with pressurised air wear safety goggles. After about 200 hours of running time the lubricant should be
replaced by a qualified STORCH Service Station.
Replacing Carbon Brushes
If worn down to 7 mm both carbon brushes should be replaced. To check or replace the carbon brushes, disconnect the
tool from the power supply. Then unscrew the four motor casing screws. Pull back the carbon brush springs to release the
tension. Release the screw holding the carbon brush guide. Remove the carbon brush.
Repeat for the other side. To reassemble reverse the procedure.
The straps on the metal of the brush unit are fitted into the same opening as the carbon parts.
If the device is not placed properly on the floor (e.g. with the cable facing down)
the mains cable can be damaged, increasing the risk of electric show and the risk
of damage to the tool.
To fit the same brushes first ensure that the brushes are replaced in exactly the
same way as before they were removed. The motor performance can otherwise be
affected and the brushes will be subject to more wear and tear. It is advisable to
send the tool to customer service unit authorised by STORCH at least once a year
for a full clean and lubrication.
To ensure safety and reliability, all repairs should be carried out in a
customer service centre authorised by STORCH.
47