Specifications - Makita HP2050 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lock button
1-2. Speed control screw
1-3. Switch trigger
1-4. Higher
1-5. Lower
2-1. Lamp
3-1. Reversing switch lever

SPECIFICATIONS

Model
Speed
Capacities
No load speed (min
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
4-1. Arrow
4-2. Speed change knob
5-1. Action mode changing lever
6-1. Grip base
6-2. Side grip (auxiliary handle)
6-3. Teeth
6-4. Protrusions
Concrete
Steel
Wood
-1
)
ENE039-1
ENF002-2
ENG905-1
noise level determined
) : 97 dB(A)
pA
) : 108 dB(A)
WA
HP2050/HP2050F
High Low
20 mm -----
8 mm 13 mm
25 mm 40 mm
0 - 2,900 0 - 1,200
0 - 58,000 0 - 24,000
362 mm
2.5 kg
Vibration
The vibration
determined according to EN60745:
Work mode: impact drilling into concrete
Vibration emission (a
Uncertainty (K) : 3 m/s
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
7-1. Chuck key
8-1. Sleeve
8-2. Ring
9-1. Depth gauge
10-1. Blow-out bulb
11-1. Vent holes
HP2051/HP2051F
High
20 mm
8 mm
25 mm
0 - 2,900
0 - 58,000
360 mm
2.5 kg
/II
total value (tri-axial
2
) : 13 m/s
h,ID
2
2
) : 2.5 m/s
h,D
2
Low
-----
13 mm
40 mm
0 - 1,200
0 - 24,000
ENG900-1
vector sum)
or less
ENG901-1