Cleaning And Service - Caframo BDC2002 Bedienungshinweise

The countdown timer and the xRx agitation cycle can be changed only when the
stirrer is stopped and the indicator lights are solid. If the indicator lights are flash-
ing the parameters cannot be changed. To reset the stirrer, power the stirrer off
and then on again.
The multifunction button can be pressed when the stirrer is running to check the
status of each function.
For safety, a "soft start" has been incorporated into the stirrer. The stirrer will ramp
up to reach the set speed to minimize splashing.
In the event of a power outage, the stirrer will stop and set parameters will go back
to their default values.
Display Codes
OL Indicates an overload condition. The load is too great for the stirrer and must
be reduced. Press the power button and enter in new parameters and start.
OH Indicates an overheat condition. The operating conditions have caused the
stirrer to overheat. Reduce stirrer loads and/or environmental temperature to
continue mixing. To reset stirrer turn power off, allow stirrer to cool and then
turn back on.

Cleaning and Service

Cleaning
Using a mild soap and water solution, wipe the housing and control panel of the
stirrer with a damp cloth. Do not use chlorine bleach, chlorine-based cleanser,
abrasives, ammonia, steel wool, or scouring pads with metal content or similar
harsh solvents or abrasives. These may damage the surface of the stirrer.
Service
Do not attempt to service or repair stirrer. If the stirrer housing is opened, the war-
ranty becomes void. Contact Supplier for return authorization and return instruc-
tions. Clean the stirrer so that it is free from any materials which may be harmful.
Provide an SDS or other safety data sheets for all chemicals used in conjunction
with this stirrer where appropriate. Place the stirrer and its parts into the original
packing to protect and prevent damage during transport. Follow shipping direc-
tions provided by Caframo when return is authorized and RMA issued.
CAUTION:
Failure to clean, service, and handle the stirrer as outlined above can cause it
to fail which could impair the safety of the user.
12