Cleaning And Service - Caframo BDC1850 Bedienungsanleitung

Other button functionality
• If the stirrer is powered off when in zero torque mode (Ncm LED flashing), the
stirrer will be in this mode when powered back on. If the stirrer is unplugged or
power is interrupted, the stirrer is reset and the feature will not be active.
• The speed can be changed any time - while the stirrer is running or in pause.
When the speed is changed, the speed in rpm is displayed while the speed is
adjusted. If torque was displayed prior to the change in speed, the display will
change back to displaying torque once the new speed is set.
• The zero torque feature can only be activated when the stirrer is running.
• When the zero torque button is pressed while the stirrer is running and rpm is
displayed, actual torque will be displayed. Press the zero torque button again,
the Ncm LED flashes indicating the stirrer is in zero torque mode.

Cleaning and Service

Cleaning
Using a mild soap and water solution, wipe the housing and control panel of the
stirrer with a damp cloth. Do not use chlorine bleach, chlorine-based cleanser,
abrasives, ammonia, steel wool, or scouring pads with metal content or similar
harsh solvents or abrasives. These may damage the surface of the stirrer.
Service
Do not attempt to service or repair stirrer. If the stirrer housing is opened, the war-
ranty becomes void. Contact Supplier for return authorization and return instruc-
tions. Clean the stirrer so that it is free from any materials which may be harmful.
Provide an SDS or other safety data sheets for all chemicals used in conjunction
with this stirrer where appropriate. Place the stirrer and its parts into the original
packing to protect and prevent damage during transport. Follow shipping direc-
tions provided by Caframo when return is authorized and RMA issued.
CAUTION:
Failure to clean, service, and handle the stirrer as outlined above can cause it
to fail which could impair the safety of the user.
12