Seltron PROMATIC WDC10 Bedienungsanleitung Seite 11

-
4 . S T E P S E T T H E H E A T I N G C U R V E S T E E P N E S S F O R T H E S E C O N D C I R C U I T
Later you can alter the set heating curve steepness with parameter P3.1.
The first and the second heating circuits are marked with their according num-
bers on hydraulic schemes.
RESET
Disconnect the controller from power supply. Press and hold the
connect power supply.
Attention! The controller will be reset and requires additional setting. When the
controller is reset, all of its previous settings are deleted.
1
This setting is not available in schemes with only one heating circuit.
S e t t h e h e a t i n g c u r v e s t e e p n e s s f o r r o o m h e a t i n g f o r t h e
s e c o n d h e a t i n g c i r c u i t .
C h a n g e t h e v a l u e w i t h b u t t o n s
C o n f i r m t h e s e l e c t e d v a l u e b y p r e s s i n g
T h e c o n t r o l l e r r e q u i r e s a c o n f i r m a t i o n o f t h e h e a t i n g c u r v e
s t e e p n e s s s e t t i n g w i t h t h e
I n c a s e y o u c h o o s e t h e w r o n g s c h e m e , r e t u r n t o h e a t i n g
c u r v e s t e e p n e s s s e l e c t i o n w i t h t h e
1 1
1
a n d .
.
b u t t o n .
b u t t o n .
button and
U s e r m a n u a l
G
E N