Special Safety Instructions - Rk Compact Montageanleitung

5.2 Special safety instructions

•
Work with the linear unit may only take place in accordance with these instructions.
•
The device may only be opened by authorized specialist personnel. In the event of a defect in
the linear unit, we recommend that you contact the manufacturer or send in this linear unit
for repair.
•
An electric drive may only be connected to this linear unit by the appropriate technical staff,
in observance of the local connection conditions and regulations (e. g. DIN, VDE).
•
Motor current monitoring for enhanced safety: Monitoring the motor current enables faults
to be detected immediately and to prevent hazards originating from the system.
•
Wear the necessary personal protective equipment (PPE) at all times during work.
•
Unauthorised modifications or changes to the linear unit are not permitted for safety reasons.
•
If the linear unit is installed in an oblique or vertical position, the guide carriage must be se-
cured to prevent slipping during work (installation, dismantling, maintenance, servicing).
•
The transverse forces, torques and speeds specified by RK Rose+Krieger GmbH for this linear
unit must not be exceeded. In dynamic operation, this must be considered for the version: Fx
2
max = m*a [m/s ].
•
Following a collision, the toothed belt, the tapped spindle, guide nut, track rail guide and run-
ner block have to be replaced - even if there is no visible damage. Spare parts information is
to be taken from the spare parts list for the relevant linear unit type.
•
The type plate must remain legible. It must be possible to identify the ratings data effortlessly
at any time.
•
Safety-relevant hazard symbols identify danger areas on the product.
•
Safety-relevant devices must be inspected at regular intervals, but at least once a year, for pro-
per function, damage and completeness.
5. Safety
33