Declaration Of Incorporation - Rk Compact Montageanleitung

1. Declaration of Incorporation

1.1 Declaration of Incorporation
As set out in Machinery Directive 2006/42/EC, Annex II, 1.B for partly completed machinery
The manufacturer
RK Rose+Krieger GmbH
Potsdamer Straße 9
32423 Minden, Germany
confirms that the named product
Mat:
AB:
Pos:
SN:
ID No.:
Bj:
complies with the requirements for partly completed machinery in accordance with EC Machinery
Directive 2006/42/EG.
The following basic requirements of Machinery Directive 2006/42/EC as set forth in Appendix I
are applied and fulfilled:
1.1.5.; 1.1.7.; 1.3.; 1.3.2.; 1.3.3.; 1.3.4.; 1.3.7.; 1.3.9.; 1.5.8.; 3.2.1.; 3.4.4.; 4.1.2.1.; 4.1.2.3.;
4.1.2.4.; 4.1.2.5.; 4.1.2.6.a), 4.1.2.6.b); 4.1.2.6.c); 4.1.2.6.d); 4.1.2.6.e); 4.1.3.; 4.2.1.; 4.2.1.4.;
4.2.2.; 4.2.3.; 4.3.1.; 4.3.2.; 4.3.3.; 4.4.1.; 4.4.2.; 6.1.1.; 6.3.3.; 6.4.1.; 6.4.3.
The following harmonised standards were applied:
DIN EN ISO 12100 – 1
DIN EN ISO 12100 – 2
DIN EN ISO 14121 – 1
RK Rose+Krieger undertakes to supply the technical documents for partly completed machinery
as set out in Annex VII B of Directive 2006/42/EC in electronic form to the national agencies in re-
sponse to a justified request.
Under the responsibility of the documentation officer
Minden / 1st March 2011
Location / Date
Putting into service is forbidden until the machine in which this partly completed machinery is in-
corporated complies with the provisions of EC Directive 2006/42/EC.
Before bringing onto the market, this must comply with the CE Directives, including documenta-
tion.
Minden / 1st March 2011
Location/Date
28
see rating plate label on the front page of these assembly instructions
see rating plate label on the front page of these assembly instructions
see rating plate label on the front page of these assembly instructions
see rating plate label on the front page of these assembly instructions
see rating plate label on the front page of these assembly instructions
see rating plate label on the front page of these assembly instructions
Machine safety - Basic definitions, general design guidelines Part 1: Basic
terminology, system engineering
Machine safety - Basic definitions, general design guidelines Part 2: Tech-
nical guidelines and specifications
Machine safety – Risk assessment – Part 1 Guidelines
Signature
Signature
Technical Director
Signatory's position
CEO
Signatory's position