Care And Cleaning; Troubleshooting - Klarstein 10030731 Bedienungsanleitung

• The first switch turns on the fire flame simulation effect.
• The second switch from the left turns on the heater at 925 watts. The third one turns
the heater on at 925 watts. If both switches are ON, the heater is on at 1850 watts.
• The fourth switch count from left turns on the fan only without heating function.
• The knob on the right adjusts the fire effect intensity. Turn this one to get the desired
fire look.
• The knob on the left is the thermostat that automatically turns the heater on and off
to maintain a constant temperature. Turn the thermostat switch clockwise increase
the desired temperature and anti-clockwise to lower it.
Notes on Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g.
due to blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect to the mains supply and switch on the appliance.

CARE AND CLEANING

• Before cleaning the appliance, disconnect it from the socket and leave to cool off.
• You can clean the exterior surface of the heater with a soft, damp cloth.
• Do not use cleaning or polishing products.

TROUBLESHOOTING

Problem
No operation / no fan.
No fire effect light.
Possible Cause and Suggested Solution
Check fuse by replacement.
Check for safety cut-off operation.
Check the bulb by a qualified electrician.
EN
13