Cutting Glass Ovals/Circles - KEENCUT OVAL 6 Bedienungshandbuch

5.4 The Craftsman Toolset
WARNING: Wear eye and hand protection when handling glass.

Cutting glass Ovals/Circles

(optional)
1. Clamp a piece of matboard on the
turntable that is larger than the glass
blank do not lay the glass on it yet.
2. Set the width and differential scales to
the desired size of oval and fit the
glass scoring tool to the cutting head.
3. Lower the cutting head and with light
pressure score the oval shape on the
matboard.
4. Measure the scored shape to confirm
the accuracy.
5. Place the glass blank on the mat-
board and lower the cutting head
onto a small piece of paper or
thin card.
6. Rotate the turntable and apply finger
pressure only to the cutting head
knob, run the glass cutting wheel off
the paper, then whilst still applying
finger pressure remove the paper.
5.4