Power Supply - Wohler CD 210 Bedienungsanleitung

Wöhler CD 210

4. Power Supply

The meter is powered by 4 AA batteries.
Install the batteries into the battery compartment on the rear and make
sure they are in correct polarity and good contact.
When battery voltage gets low, a battery icon and "Lob" will appear on the
LCD. (Fig. 4.1). At the same time a beeper sounds. The CO -sensor cannot
2
work under low voltage, so it beeps to indicate failed CO -measurement
2
(press any key but the ON/OFF-key to stop the beeps) and the readings
will not be displayed. Please replace with fresh batteries.
Fig. 4.1: Display when battery voltage gets low.
Hotline: +49 2953 73-211 Fax: +49 2953 73-250
26