•
Verbinden Sie das Stützgerüst (4) mit dem Basisrahmen (2). Verschrauben Sie mit zwei M10X70mm Hex-Schrau-
ben (80), vier M10 Unterlegscheiben (92) und zwei M10 Muttern (96).
•
Entfernen Sie die zwei M10X20mm Hex-Schrauben (85) und M10 Unterlegscheiben (92) von den Gewichtsführun-
gesrohren (5).
•
Bringen Sie die obere Traverse (3) an der Gewichtsführung (5) an: nutzen Sie zwei M10X20mm Hex-Schrauben (85)
und M10 Unterlegscheiben (92).
•
Verbinden Sie dann die obere Traverse (3) mit dem Stützgerüst (4): nutzen Sie zwei M10X70mm Hex-Schrauben
(80), vier M10 Unterlegscheiben (92) und zwei M10 Muttern (96).
•
Attach the Support Frame (4) to the Base Frame (2), using two M10X70mm Hex Bolts (80), four M10 Washers (92)
and two M10 Nylon Nuts (96).
•
Remove two M10X20mm Hex Bolts (85) and two M10 Washers (92) from two Weight Guide Tubes (5).
•
Attach the Upper Cross Beam (3) to the Weight Guide Tube (5), using two M10X20mm Hex Bolts (85) and two M10
Washers (92).
•
Attach the Upper Cross Beam (3) to the Support Frame (4), using two M10X70mm Hex Bolts (80), four M10
Washers (92) and two M10 Nylon Nuts (96).
Aufbau / Assembly
Schritt 3
Step 3
15