Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Base plate (Fig.2):
Remove the nut in the middle of the base plate by means of the enclosed
face spanner. If necessary, counter hold with a screw driver in the work
spindle.
Attention!
Before you start working, check whether the accessory has the exact
position.
Let the machine start running in a safe position for a short time. In
case the machine does not run easily, immediately stop working.
Dust Extraction
Dust which appears during work is harmful to health. For this reason, use
an industrial vacuum cleaner while sanding.
The appropriate Wet/Dry Vacuum Cleaner is available as accessory.
Directly connect it to the nozzles which are meant for it on the dust hood.
Changing the brush rim (Fig.3):
In case of wear of the brushes (extreme amount of dust during sanding),
the brush rim has to be replaced.
For this purpose, pull the worn brush rim out of the guide way and put the
new one in the flute which is meant for it.
Connect the lead cable of the long reach sander with the industrial vacuum
cleaner and then connect the extraction hose with the dust connection of
the sander. Lead the extraction hose and the cable to the back away from
the machine. Activate the switch-on automatic on the vacuum cleaner.
Switch the machine on and put it carefully on the surface you want to work
on. Hold the machine with both hands and move it in a linear or rotary way.
Do not overload the machine by pressing with excessive force! The best
sanding results are achieved with moderate press-on pressure.
The flexibly mounted grinding head enables to the sander to best match the
grinding surface. However, please take care not to stretch the flexible drive
shaft excessively.
For better control of the machine on the grinding surface, you can regulate
the suction force of the grinder depending on the suction force of the
grinder. To do so, turn the controller on the suction hood (see Fig. 4) to the
corresponding setting.
You can reach high areas by attaching an extension tube (supplied).
!
Attention!
Do not touch rotating parts!
Handling
20
Werbung
