To operate the fan, rotate the switch knob to the desired speed Low(1),
Med(2), High(3).
Adjust the fan to your desiredv angle by moving the head up or down.
• Locate and mark the position on the wall where the fan will be mounted (preferably at a wall stud).
• Insert a #8 (4*30) screw into the wall stud. The screw is not included and can be purchased at a
hardware store.
• Leave approx.5/8" (1.6cm) of the screw exposed.
• Line up the opening of the base of the fan with the screw and hang the fan on the wall
REMOVAL OF GRILL FOR CLEANING
• Be sure your fan is in the OFF position.
• Unplug the fan before cleaning.
• Use only a soft, damp cloth to gently wipe the fan.
• DO NOT immerse the fan in water and never allow water to enter the Motor Housing.
• DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
• Remove the 2 screws located in the rear of the fan at roughly 2 and
7 o'clock positions.
• Place the circulator facing you and position your hands at the 10 and
2 o'clock positions, lift up and back on the outer grill to release the grill clips.
• Replace by linking up the clips with the holes and firmly snapping the grill back into place.
• Replace with the screws.
To clean the motor caop and inlet ribs: Use a common household vacuum. Do not use water to
clean these parts of the Air Circulator.
To clean grill: Remove grill (see Removal of Grill for Cleaning section) and dust or wipe with a damp
cloth.
To clean blade: Wipe with a damp cloth. If your Air Circulator is used in a greasy environment, mild
soap may be necessary. Do not use solvents.
To clean base: Wipe with a damp cloth.
WALL MOUNTING
CLEANING & MAINTENANCE
7