Control Panel And Operation - Klarstein 10031372 Bedienungsanleitung

Control Panel and Operation

POWER
The indicator of POWER will flash after plugged in, and then the machine enters standby state. It will start to
work by pressing POWER button, accompanying indicator lighting. During operation, pressing this button, the
machine will return to standby state.
SELECT
This button is for selecting the size of ice. The default setting is large ice, if the small one is needed, pressing this
button is available. When you select the desired size, corresponding indicator of S (small) or L (large) will be on.
Press and hold „SELECT" button for 3 seconds to activate pipeline self-clean process, which takes „pump
water in for 30 seconds---water tank run to drain out water" as a circle, and this circle will run for 5 times. Flas-
hing of indicators of „S" and „L" will take place in turn until self-clean process is over and the machine enters
standby mode. Take away the plastic plug to drain water and then whole process is finished.
ADD WATER
When the indicator of this button turns to red, it means insufficient water to water reservoir, you need to add
enough water and press POWER button to restart the machine.
ICE FULL
When the ice reach to the max storage capacity, the indicator of this button will flash, and the machine will
stop working. What you need to do is pouring out the ice, if the position of ice is lower than the position of ice
bin full sensor, the machine will restart automatically.
9