Control Panel Operation - Klarstein Coolio Bedienungsanleitung

CONTROL PANEL OPERATION

POWER Power switch
CLEAN
Cleaning button
ICE FULL Ice full alarm
1. POWER: Plug in the power and the source indicator flashes. Press the POWER
button, the power indicator light is always on, the machine will start the de-icing
function first, then the ice block will be automatically produced according to the
selected mode. After the ice-making is completed, the ice will be removed, and
then the ice-scraping function will be entered.
2. SELECT: Select the ice size mode. The default is the big ice production mode.
The selected mode: SMALL: small ice selection. LARGE: big ice selection, the
corresponding indicator light is on. The production time of small ice is 8 minutes
and 30 seconds, and the production time of big ice is 9 minutes and 30 seconds.
3. CLEAN: After cleaning the button, press the cleaning button, start the motor, then
start the pump to pump water, so cycle, stop for 4 minutes.
4. ADD WATER: Water shortage alarm: When this red is on, it means there is water
shortage in the water tank. You need to add water and press the POWER button to
restart the machine.
5. ICE FULL ice alarm: When the ice reaches the maximum amount of ice storage
container, the "ICE FULL" light flashes and the machine stops. At this time, the ice
needs to be poured out. When the ice position is lower than the full sensor position,
the machine automatically restarts.
SELECT Mode selection
SMALL Small ice selection
LARGE Big ice selection
ADD WATER Water shortage alarm
EN
17