Before First Use; Use And Operation - Klarstein 10013323 Bedienungsanleitung

1. Remove the appliance from the packaging and remove the protective film from all surfaces. Remove the Ice
Spoon, Water Inlet Tube, Water Drainage Pipe and Sealing Washers from the ice storage cabinet.
2. Place the device on top of an even and safe surface which supports the weight of the device. Choose a
surface where the ice maker is not exposed to direct sunlight, or close to a direct source of heat such as a
cooker, oven or radiator. When positioning the ice maker, maintain a distance of 20 cm (7 inches) between
the appliance and walls o r other objects for ventilation. Increase this distance if the obstacle is a heat source.
Position the device in a way so that the power plug is always accessible. Set up the device near water supply
connection. If necessary, adjust the screw legs of the ice maker to make it level
3. Connect one end of the Water Drainage Pipe to the water outlet connector on the rear of the ice maker. Attach
the other end of the pipe to a plumbed in stand waste pipe or container suitable for collecting waste water.
Connect one end of the Water Inlet Tube to the 3/4 Inch screw type connector of the water tap so as to get
the drinkable tap water. Be sure to put sealing washers in both ends of the water inlet tube before connecting.
Connect the other end of the inlet tube to the water inlet connector.
If using the ice maker for the first time (or after a period of inactivity) please discard the first two batches of ice.
This cleans the internal systems of the ice maker.
1. Connect the device to a grounded single power socket.
2. Press the Power switch to the ON position [I]. The Switch light illuminates and the appliance stm1 to work.
The first 5 minutes is used for the self-inspection of the ice maker. Then it will begins the ice making process.
Indicators-Lights
• ICE FULL: As soon as the ice storage cabinet is full, the indicator on the display panel will light on and the ice
maker will stop automatically. Production resumes once ice has been removed from the cabinet.
• WATER LOW: If water supply is insufficient, the indicator will light on and the ice maker will stop operation
automatically.
• FAULT: If any error or failure occurs, the „FAULT" indicator will light on and the ice production stops. For
further information see „Troubleshooting".
Important Hints on Use
• Switch off the device and disconnect it from power supply (pull the power plug), when it is not in use.
• Do not switch on the device immediately after it stops automatically (caused by insufficient water supply,
ice storage cabinet too full, current interruption). Wait at least 3-5 minutes before restm1 it in order to avoid
damages of the compressor.
• NOTE: If the device is not used for a longer period of time, drain the water from the water tank via the drain
screw at the back of the device (some model no drain screw). Wipe dry the water tank using a dry cloth.
9

Before first Use

Use and Operation