Zeiss Stemi 305 Bedienungsanleitung Seite 20

ZEISS
Fig. 10 Installing the stereo microscope
Fig. 11 Setting the ease of motion of the
focusing drive
18
INSTALLATION
Installing the stereo microscope
•
Insert the connection cable (Fig. 10/3) supplied
with the device into the socket on the Stemi
body and in the socket on the Stemi mount.
•
Insert glass plate or B/W plastic plate (Fig. 10/7)
in the mount in the base of the stand.
To this effect, press the glass plate or the B/W
plastic plate against the spring (Fig. 10/8) and
make it lock in.
435063-7044-010
Stereo microscope
Installation of an additional reflected-
light illuminator has been described in
section 3.3.1 on page 19.
If necessary, the ease of motion of the
focusing drive can be set as required
on a case-by-case basis by adjusting
the two focusing buttons (Fig. 11/1
and 2) in opposite directions.
The ease of motion must not be set so
loosely that the drive moves down-
wards by itself. This might damage the
microscope or the specimen.
Stemi 305
04/2015