Siemens SICAM P850 Produktinformation Seite 62

DIN-rail assembly according to EN 60750
Guiding of the
snap-on clip
DIN rail
Figure 10-2 DIN-Rail Assembly
1. Pull down the release device at the snap-on clip and
hold it in this position.
2. Slide the device with the guiding of the snap-on clip
on to one side of the DIN rail.
3. Move the device into the desired position on the
DIN rail.
4. Release the release device. The device is now
firmly mounted on the DIN rail.
NOTE
The snap-on clip is adjusted to a certain height setting by the
manufacturer. You can change this position if necessary. To do
so, lever the release device out of its guiding (no special tool
required) and move the release device into the desired
position. Subsequently, press the release device back into its
guiding.
18
Pulling direction
SICAM P850/P855 7KG85xx, Product Information
E50417-B1050-C482-A3, Edition 03.2013
Snap-on clip
Release device