Top Panel; Network Standby - Yamaha MusicCast SUB 100 Bedienungsanleitung

Top panel

1 GAIN knob
This knob adjusts the volume of this unit. Adjust the
volume appropriately for your playback device.
(→ p. 15 "Adjusting the volume balance")
NOTE
While you're changing the volume, the color of the
2 STATUS indicator shows the volume setting.
Volume Color of the STATUS indicator
Minimum value
Low – Medium
Medium – High
Maximum value
Auto power standby
If this unit is not operated and no playback occurs for 20
minutes, it automatically enters standby mode.
NOTE
● Thirty seconds before auto power standby occurs, the
STATUS indicator begins flashing, and goes dark
when standby occurs.
● Auto power standby does not operate if you're using a
MusicCast connection, or if the rear panel INPUT
switch is set to ANALOG.
Flashing blue
Blue – Purple
Purple – Red
Flashing red
PARTS AND THEIR FUNCTIONS
1
2
2 STATUS indicator
The color and lit/flashing status of this indicator shows
the input source that is selected or the status of this unit.
(→ p. 17 "STATUS indicator operation table")
3
Wireless LAN indicator
The lit or flashing state of this indicator shows the
operating status of the wireless network connection.

Network standby

This unit's network function is enabled even when the
power is in standby mode.
NOTE
When in network standby, the STATUS indicator is lit
orange.
Eco standby mode
When eight hours have elapsed after the network was
disconnected, the unit enters eco standby mode to save
power.
NOTE
When in eco standby mode, the STATUS indicator is
unlit.
With an advanced energy saving design,
this product achieves a low power
consumption of not more than two watts
when in Network Standby mode.
English
3
9
En