Storing Your Own Sound Adjustments - JVC KD-SX992R Bedienungsanleitung

• When "CEQ LINK" is set to "LINK ON"
The selected sound mode can be stored in
memory for the current source.
Each time you change to the same source, the
same sound mode is also recalled and shown
on the display. The C-EQ indicator also flashes.
• When "CEQ LINK" is set to "LINK OFF"
The selected sound mode effect applies to any
source.
Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press MODE.
2
Press EQ (equalizer) while "MODE"
still on the display.
Sound mode indicator flashes.
Ex.: If you have selected "ROCK" previously
3
Select the sound mode you want to
adjust.
24
"MODE" appears on the lower
part of the display, and the
number buttons work as
different function buttons.
The last selected sound mode
is recalled and applied to the
current source.
4
Select the item you want to adjust.
• See page 22 for details.
5
Adjust the level.
Ex.: When you adjust "TRE"
6
Repeat steps 4 and 5 to adjust the
other items.
7
Repeat the same procedure to store
other sound modes.
To reset to the factory settings, repeat the
same procedure and reassign the preset values
listed in the table on page 23.
To increase the level.
To decrease the level.
Equalization pattern
changes as you adjust
the bass or treble.