Safe Operation - Oase PondJet Eco Gebrauchsanleitung

Safe operation

 The impeller unit in the pump contains a magnet with a strong magnetic field that may affect the operation of pace-
makers or implantable cardioverter defibrillators (ICDs). Always keep magnets at least 20 cm away from implanted
devices.
 Never operate the unit if either the electrical cables or the housing are defective!
 Do not carry or pull the unit by its electrical cable.
 Route cords/hoses/lines in a way that they are protected against damage, and ensure that they do not present a
tripping obstacle.
 Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
 Only execute work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
 Only use original spare parts and accessories for the unit.
 Never carry out technical modifications to the unit.
 The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
 Only operate the unit if no persons are in the water!
Installation
The unit must be completely assembled before it can be placed in the pond. Individual assembly steps:
 Fitting the nozzle body
 Fitting the pump
 Fitting the nozzle
Fitting the nozzle body
How to proceed:
 B
Insert the nozzle body into the float.
Insert the screws with washers through the holes in the nozzle body.
– Ensure that the screws protrude from the bottom of the float.
Screw the self-locking nuts with washers onto the screws and tighten.
– Only tighten the screws until the nozzle body is fixed without play (do not overtighten).
Fitting the pump
How to proceed:
 C
Screw the reduction element onto the pump outlet up to the stop.
Screw the pump and reduction element with flat seal onto the inlet of the nozzle body and hand tighten.
Align the pump.
– Ensure that the filter basket of the pump is in line with one of the three recesses in the float.
– Do not turn the pump too far in order to avoid damage.
– Turn the pump back, if necessary, to the previous recess.
Screw the stud bolts into the two threaded holes on the right and left next to the pump and tighten.
– Select the centre of the three threaded holes on both sides.
Screw the nuts onto the stud bolts up to the stop.
– The nuts serve as a support for the retaining brace.
Fit the retaining brace.
 D
Insert the Allen screws through the base of the pump and through the retaining brace, screw on the nuts together with
tooth lock washer and tighten.
Turn the nuts on the stud bolts up as far as the retaining brace.
Screw the nuts with washer onto the stud bolts and tighten.
- EN -
15