When The Oven Is Working; Interrupting A Cooking Cycle; Altering Parameters - AEG KS7415001M Gebrauchsanweisung

WHEN THE OVEN IS WORKING

Interrupting a cooking cycle

You can stop the cooking process at any time by pressing the Cancel key once.
The oven incorporates a steam-reduction function that is activated when the Cancel
key is pressed to gradually release the steam from the cavity, so that there is no
sudden rush of steam when the appliance door is opened.
This function takes around 3 minutes and during it the display shows the word
"VAP".
Warning! When opening the door during or upon completion of the cooking
cycle, be careful of the flow of hot air and/or steam coming out of the cooking
chamber. Step back or to the side to avoid burns.
At this point:
• The steam generation is interrupted.
• The cavity walls and the water tank are still very hot. Danger of burning!
• The timer stops and the display shows the remaining operating time (if this has been
set).
If you wish, at this point you can:
1. Turn or stir the food to ensure it will be evenly cooked.
2. Change the cooking parameters.
To restart the process, close the door and press the Start key.

Altering parameters

The operating parameters (duration and temperature) can be altered when the oven
is operating or when the cooking process has been interrupted by proceeding as
follows:
− To alter the duration, press ''+'' and ''- -'' keys. The new defined duration is immediately
valid.
− To alter the temperature, press the Parameter Selection key and the display and
respective light start to flash. Alter the parameter by pressing the ''+'' and ''- -'' keys and
confirm by pressing the Parameter Selection key again.
Cancelling a cooking cycle
If you wish to cancel the cooking process, press the Cancel key twice.
You will then hear 3 beeps and the message "End" will appear on the display.
End of a cooking cycle
At the end of the set duration or when you press the Cancel key twice to finish the
cooking cycle the oven starts the steam-reduction function.
This function gradually releases the steam from the cavity, so that there is no sudden
rush of steam when the appliance door is opened.
This function takes around 3 minutes and during it the display shows the word
"VAP".
At the end of this process you will hear three beeps and the display will show the
word "End".
When the oven is working
22