Specifications; Additional Safety Rules - Makita GD0601 Betriebsanleitung

ENGLISH
1. Slide switch
2. Wrench 13

SPECIFICATIONS

Max. collet capacity
Max. wheel point diameter
No load speed (min
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be sure
that you understand their meaning before use.
............... Read instruction manual.
................ DOUBLE INSULATION
................ Wear safety glasses.
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Explanation of general view
3. Collet nut
4. Wrench 13
Model
-1
)
Net weight
Safety class

ADDITIONAL SAFETY RULES

END202-2
1. Always use eye and ear protection. Other personal
protective equipment such as dust mask, gloves,
helmet and apron should be worn.
2. Use only wheels with correct size and wheels
having a maximum operating speed at least as
high as the highest No Load Speed marked on the
tool's nameplate.
3. Check the wheel carefully for cracks or damage
before operation. Replace cracked or damaged
wheel immediately.
4. Observe the instructions of the manufacturer for
ENE050-1
correct mounting and use of wheels. Handle and
store wheels with care.
5. Before using the tool on an actual workpiece, test
ENF002-1 run the tool at the highest no load speed for at
least 30 seconds in a safe position. Stop
immediately if there is any vibration or wobbling
that could indicate poor installation or a poorly
balanced wheel. Check the tool to determine the
cause.
6. Check that the workpiece is properly supported.
7. Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
8. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
9. Watch out for flying sparks. Hold the tool so that
sparks fly away from you and other persons or
flammable materials.
10. Pay attention that the wheel continues to rotate
after the tool is switched off.
11. Hold the tool firmly.
12. Keep hands away from rotating parts.
13. Do not leave the tool running. Operate the tool
only when hand-held.
5. Side handle
GD0601
6 mm or 6.35 mm (1/4")
38 mm
25,000
359 mm
1.6 kg
/II
ENB044-3
3