Connecting Drives And Hand Switches; Connecting Drives; Connecting The Manual Control Switch - Phoenix Mecano LBG1 Montageanleitung

7. Life Phases

7.3 Connecting drives and hand switches

7.3.1 Connecting drives

Connect the drive to the LBG controller
Up to three drives can be connected to the LBG controller.
If only one drive is connected to the controller, this must be attached to the connection EZ1 of the
controller.
Only drives of the same design should be connected to the controller.
Procedure:
•
Connect the first drive to the connection of the controller designated as EZ1.
•
Connect each other drive to the consecutive connections (EZ2, EZ3) of the controller.
Connect the drive to the LBS controller
It is essential that two drives must be connected to the LBS controller. A maximum of three drives
can be connected.
Only drives of the same design should be connected to connections EZ1 + EZ2 of the controller.
Procedure:
•
Connect the first drive with potentiometer to the connection of the controller designated as
EZ1.
•
Connect the first drive with potentiometer to the connection of the controller designated as
EZ1.
•
Connect a third drive without potentiometer to the connection of the controller designated
as EZ3.

7.3.2 Connecting the manual control switch

You can connect the following hand switches to the controller: LBH3.5A.
•
Plug the cable of the hand switch into the connection for the hand switch.
30