Product Information; Mode Of Operation; Technical Data; Duty Cycle - Phoenix Mecano LBG1 Montageanleitung

6.1 Mode of operation

The LAMBDA Electric cylinder and LAMBDA Colonne drives are traversed using the LBG cont-
rollers and LBS controllers. Depending on the version, up to three drives can be connected to the
controller. You use a hand switch to operate the controller.

6.2 Technical data

Type
Input voltage
Supply voltage (Extracts /
Retracts)
Output current
Power

Duty cycle

Protection category
Housing dimensions
Primary fuse rating
Protection class
Ambient temperature
6.2.1 Duty cycle
It is absolutely necessary that you observe the permitted controller duty cycle of 30 per cent ED/10
min. (switch on the drive for max. 3 minutes and then rest for 7 minutes), in order to avoid
damage.
You must take note of duty cycle of the drive connected in all cases. In some cases, this may be
lower. You will find the stipulated duty cycles on the type plate.
If you do not observe the duty cycles, you can damage controllers and drives!
LBG
LBG1 (for 1 drive)
LBG2 (for up to 2 drives)
LBG3 (for up to 3 drives)
230 VAC / 50 Hz (Standard); 115 VAC / 50-60 Hz (option)
24 VDC (standard)
24 VDC / 17 VDC (option)
17 VDC / 17 VDC (option)
8 A
192 Watt
max. 30 per cent (ED 3/10 min.)
170 x 135 x 84 mm
At 230 VAC; 1.2 A
At 115 VAC; 3.1 A
II (insulated construction)
+5 deg. Celsius / +60 deg. Celsius

6. Product Information

LBS
LBS2 (for 2 drives that run synchro-
nously)
LBS3 (for 2 drives that run synchro-
nously + 1 drive without synchronous
run function)
24 VDC (standard)
2x8 A
382 Watt
IP 54
180 x 182 x 166 mm
At 230 VAC; 1.25 A (2x)
At 115 VAC; 3.15 A (2x)
25