Installation - Klarstein 10029629 Sicherheitshinweise

• In locations where there is frequent lightning, it is advisable to use surge protectors.

Installation

Installing
Unpack and remove all of the protection and adhesive strips from the packaging around and inside the wine
cellar.The wine cellar must be positioned such that the plug is accessible. Release the power cord. Move your
wine cellar to its final location. The wine cellar should be installed in a suitable place where the compressor
will not be subject to physical contact.
Leveling your wine cellar: Wine cellar must be leveled BEFORE loading your wines.
Your wine cellar is equipped with 4 adjustable feet to facilitate easy leveling. VINICOLE recommends that
you tighten the back feet to the maximum and adjust the front feet to level the wine cellar.
• This wine cellar is front venting but is not designed to be fully integrated behind a joinery door.
• This appliance requires at least 5 mm clearance on both sides and top, 30mm clearance at the rear, to
facilitate installation, removal, servicing and ventilation.
• This unit draws air from the rear and expels through the metal grid under the door at the front.
18