Machine Set-Up - LAVAZZA EP MINI Bedienungsanleitung

The company will not be responsible for any
damages in the following cases:
• incorrect use and not in conformity with the
intended purpose;
• repairs made by other than an authorised
service facility;
• tampering with the power cable;
• tampering with any part of the machine;
• use of spare parts and accessories other
than the originals;
• failure to decalcify;
• storage in rooms below 4°C (39,2°F);
• use below 5° C (41°F);
• use over 40° C (104°F);
• use of capsules other than those indicated.
The guarantee is no longer valid in these
cases.
MACHINE START UP
Set the machine on a flat, stable surface, far away
from water or heat sources. Do not connect the
machine to the mains supply. Damage caused
by failure to apply these instructions will void the
guarantee.
Lift out the water tank and open the lid.
1

MACHINE SET-UP

2
3
Rinse the tank before use.
Fill the water tank up to the MAX level indicated
using only fresh, non-bubbly, drinking water.
The water level should never exceed the MAX
indication and it must always be main-
tained above MIN. Only use non-carbonated
fresh water. Hot water and other liquids can
damage the tank.
Do not operate the machine without water. Always
make sure that the water in the tank is above the
specified MIN level.
Fit the power plug into the power socket, then
press the master switch and set it to position I.
The supply button will blink.
When the supply button is ON steadily, the ma-
chine will be ready for use.
The machine will, when it is powered on, fill the
hydraulic circuit by activating the pump for a brief
time.
EN