Fill With Water; Switching On - Silvercrest SFB 120 B2 Bedienungsanleitung

GB

Fill with water

IE
CY

Switching on

8
WARNING! RISK OF INJURY!
► First connect the appliance to the power source when you have fi lled it with
water.
WARNING - PROPERTY DAMAGE!
► Fill the appliance only with suffi cient water such that the "Max" marking is
not exceeded when your feet are placed in it. It therefore needs less water
than to the "Max" marking when it is being fi lled, because the water level
rises when you put your feet into the appliance. Otherwise the water could
overfl ow during the foot bath.
♦
Fill the appliance with warm or cold water.
INFORMATION
► The purpose of the heating function is not to heat cold water. It should
simply maintain the temperature of the water.
► You can also use special bath additives. However, please refrain from using
foam-producing bath additives.
► You can also use Position
water!
RISK OF ELECTRIC SHOCK
► Do not insert the plug into the mains power socket when your feet are
already in the appliance.
♦
Insert the plug into the mains power socket.
♦
Sit comfortably on a chair. But do not put your feet into the water yet!
♦
Place the function switch 1 to the desired combination:
– Position 0 :
– Position :
– Position :
– Position :
, infrared light
Appliance is switched off .
Infrared light + Massage
Heat + Bubble
Infrared light +Massage
+ massage without
+ Bubble + Heat
SFB 120 B2