Electrical Installation - Oase Water Quintet Creative Gebrauchsanleitung

- GB -
Control box and transformer installation
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
− Install transformer and 12 V control box at a dry, splash-water protected place.
− Only use the 12 V control box with a protection hood.
− Install both the transformer and the 12 V control box at a minimum safety distance of 2 m from the water.
Install the 12 V control box at a place protected from sun radiation (max. 40 °C).
Variant 1 (E):
− Push the ground stake (5) fully into the ground at the desired position.
− Slide the 12 V control box (3) onto the ground stake (5).
Variant 2 (F):
− Screw the 12 V control box (3) to the ground using 4 screws (13) (not included in our scope of delivery) through the
fastening slots (14) in the housing of the 12 V control box (3).
Installation of the transformer (G):
Install the transformer (2) close to the 12 V control box (3).
Note: Ensure that the cables are routed strain relieved!

Electrical installation

Attention! Sensitive electrical components.
Possible consequence: The unit will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Connect the unit to the 12 V control box (G, H):
− Plug the pump plugs (18) as well as the LED light nozzle plugs (20) into the respective sockets for the pump (19)
and the LED light nozzles (21) of the 12 V control box (3). Note the order of the plugs (plugs are marked).
− Insert the connection cable (17) of the transformer in the rear socket (15) of the 12 V control box (3), then screw-
tighten the cable with the union nut (16).
− Fit the protection sleeve (4) over the 12 V control box (3).
Start-up
Switching on the unit: Plug the power plug of the transformer into the socket. The unit will start with program 1 (see
chapter 'Control/Operation').
Switching off the unit: Disconnect the power plug of the transformer.
14