Sure Microchip Cat Flap Bedienungsanleitung Seite 20

7
8
10mm
9
50mm
10
11
12
19
Now remove all of the material in the centre using the most
suitable tools for the material you're cutting. We do not
recommend that you cut through to the outside in one go.
Cut away material on the inside of the house first and then
move outside to cut the remainder of the hole. Try to keep the
hole within the outlined area otherwise it will be too big.
We recommend using one of the tunnel extenders to make
sure you have a clear path through the wall. Once this is
the case, clear away any dust and debris.
To extend the cat flap's tunnel through to the outside
wall, you need to use the tunnel extender accessories
to make up this length. To calculate how many
extenders you will need, please go to page 17. It is
important to remember that the end has to stick out by
at least 10mm (3/ 8 ") for the external frame to rest on.
Stack the tunnel extenders together and then attach them
to the end of the cat flap's tunnel, using all weather tape
between each join to hold them together. Do not glue the
tunnel extenders or cat flap together. From the inside of the
house, feed the extended tunnel into the hole in the wall until
the cat flap is flush against the wall. If no adjustment to the
hole shape or size is needed then you are at the point where
you can attach the cat flap to the inside of the house.
The cat flap can be secured directly to your inside wall.
To access the screw holes needed, you have to unscrew
the front frame from the tunnel. To do this, first remove
the battery cover and screw covers, then unscrew the 4
screws and lastly pull the tunnel and front frame apart.
Now locate the 4 screw holes, they are the
larger holes in the corners of the cat flap.
Mark the hole positions using a sharp pencil.