Connection - Kenwood DNX9280BT Kurzanleitung

Connection

Connector A
Black (Ground wire)
Yellow (Battery wire)
8 6 4 2
7 5 3 1
Red (Ignition wire)
8 6 4 2
7 5 3 1
Connector B
⁄
Connect to the vehicle's parking
brake detection switch harness.
Light Green (Parking sensor wire)
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
⁄
Connect either to the power control terminal
when using the optional power amplifier, or to
⁄
24 | Quick Start Guide
Orange/White
PRK SW
For safety reasons, be sure to connect the parking sensor.
Connect to vehicle's reverse lamp harness
when using the optional rear view camera.
⁄
To use the steering wheel remote control feature, you need an
exclusive remote adapter (not supplied) matches your car.
When this terminal is not in use, leave its cap on.
To connect the Kenwood navigation
system, consult your navigation manual.
the antenna control terminal in the vehicle.
If no connections are made, do not let the cable come out from the tab.
Antenna Cord
Orange/White (Dimmer control wire)
To steering remote
FM/AM antenna input (JASO)
ILLUMI