Analogue Depth Scale; Reset Trip Log; Contrast - Vetus COMBI4 Bedienungshandbuch Und Einbauanleitung

4.1.5 Analogue depth scale (St. 5)
The analogue scale shows the depth
graphically.
The depth can also be read when using
this scale when the main screen displays
another function, for example the speed.
The depth can be displayed in 2 ways
when using this scale and it can also be
switched off.
In setting 1 the dis-
tance between the
single line on the
right and the bar on
the left represents
the depth. The bar
on the left repre-
sents the bottom of
the water.
In setting 2 the
bar represents the
depth.
In both settings 1 line represents 10 cm
(Ft: 1 line = 0.2 ft) and so the maximum
depth that can be shown is 6 metres
(Ft: 12 ft).
Selecting the analogue depth scale type
1, type 2 or switching off.
• Press when in the main menu to
open the menus.
• Press 4x to select the depth scale
menu (St. 5 DEPTH BAR).
• Press to open the depth scale
menu.
• Press /
• Press briefly to activate the set
value and return to the main menu or:
Press for longer than two sec-
onds to return to the main screen.
22
100609.01
to select 1, 2 or OFF.
4.1.6 Reset Trip Log (St. 6)
The Trip Log (trip recorder) can be set to 0
when starting a new trip.
• Press when in the main menu to
open the menus.
• Press 5x to select the reset trip
log menu (St. 4 RESET LOG).
• Press to open the trip log menu.
• Press /
YES.
• Press briefly to activate the set
value and return to the main menu or:
Press for longer than two sec-
onds to return to the main screen.
4.1.7 Contrast (St. 7)
The screen contrast of the compass can
be adjusted to the viewing angle. Set a
contrast level between 0 (OFF) and 9.
• Press when in the main menu to
open the menus.
• Press 6x to select the contrast
menu (St. 7 CONTRAST).
• Press to open the contrast menu.
• Press /
contrast level.
• Press briefly to activate the set
value and return to the main menu or:
Press for longer than two sec-
onds to return to the main screen.
to select NO or
to select the desired
COMBI 4