Telcoma T100 Installationsanweisungen Seite 42

GB
FINAL TEST AND INSPECTION
Always carry out a final test and inspection after having completed all the programming.
- Check correct operation of the protective devices (anti-crushing system, stop pushbutton, photocells,
safety edges, etc.).
- Check correct operation of the warning devices (flashing lights, open gate warning light, etc.).
- Check correct operation of the control devices (P/P button, remote controls, etc.).
IMPORTANT RECOMMENDATIONS CONCERNING INSTALLATION
- Only qualified personnel having the legal requirements must install the automation according to
the principles of good workmanship and in conformity with the machinery directive 98/37/CE and
standards EN 12453 and EN 12445.
- Check that the existing structures (posts, hinges, leaves) are stable in relation to the forces deve-
loped by the motor.
- Check that suitably robust limit stops have been installed for end of gate opening and closing.
- Check the state of the cables that are already present in the system.
- Analyse the hazards connected with the automation system and adopt the necessary safety and
signalling devices accordingly.
- Install the commands (e.g. the key selector) so that the user is not placed in a hazardous area
when using them.
- Upon completion of the installation, test the safety, signalling and release devices of the automa-
tion system several times.
- Apply the CE label or plate with information regarding the hazards and identification data on the
automation.
- Give the end user the instructions for use, the safety recommendations and the CE declaration of
conformity.
- Ensure that the user has understood the correct automatic, manual and emergency operation of
the automation system.
- Inform the user in writing (e.g. in the instructions for use) of any unprotected residual risks and
of foreseeable misuse.
- Inform the user in writing (in the use instructions for example):
Of possible non secluded residual risks and of foreseeable improper use.
To disconnect the power supply when cleaning the area that is automated or when perfor-
ming small maintenance operations (e.g.: repainting).
To frequently control that no visible damage has occurred to the automation, and to inform
the installer immediately if damage is noticed.
Not to allow children to play in the vicinity of the automation.
Prepare a maintenance schedule for the automation installation (at least once every 6 months for
the safety devices), recording the work carried out in a special book.
In line with its continual product improvement policy, both in aesthetic and functional terms,
TELCOMA Srl reserves the right to make changes at any time without notice.
39